The nylon cordura is resistant to water and melt. These rollers are easy care, just remove the tie and wash in the cold, hang or place flat to dry. We wear 3 sizes in our standard rollers, 10, 12, and 15 wide.
If your tools are very close to the width of the roller, you can mount a size, as the thickness of the handle takes a little of the width. All the rollers have 16 tool pockets and 2 spacers, the spacers are an ideal place to keep your pencil. The 10-inch roller pockets are 4" deep (10 cm) x 2.5" wide (6 cm). 12 inches roll-pockets are 5" depth (12.5 cm) x 2.5" wide (6 cm). The 15" roll pockets are 6.5" deep (16.5 cm) x 2.5" wide (6 cm).
Made from 1000 deniers cordura nylon. Paracord loop tie through a grommet for easy replacement. Is it as simple as yes. I find the flat pocket design and alternative spacing make it the best roll you can buy for a large collection. There is no need for gusset because the pockets will accommodate almost all the scissors on the market.
There is no need for bulk flaps when tools nest against each other. This is how it works. The pockets are compensated on both sides of the roller. Slide your handle into the pocket and the commercial end of your tool rests between the two opposite pockets.
This prevents the tools from contacting each other. Not only are your tools easy to identify, they never cross the bottom of a pocket. The alternating design even allows to roll.
Once you have rolled it, your tools will roll safely, unable to slide as they are interlocked. Yes, you can even return your bord-in tools if you have shields. Conu, cut and sewn in the montana by roxy.